I’ve Just Started a Lanw Blog
Home Lawn green , Korai-Shiba , photo , TM9
The weather is good and the sky is beautifully clear, though it is a little chilly. But it is not about lawn care today. I am preparing Fuyu-gakoi (winter covering) for the conifer and ash in the entrance. We live …
There are no good photos in the 4th year, in 2013. This is March 30, 2013. Nearby in the photo are weeds, but not lawn yard yet. The lawn in distance is in brawn color, because we burned the lawn …
We purchased Baroness push electric lawn mower, LM12MH in July 2015. Though I was interested in it since before, 178,200 yen inclusive of tax (as of Dec 2015) was too expensive. In addition, because I was satisfied the previous mowers, …
This is the backyard lawn today, in December 20, 2015. Though it looks a little green this side, it’s completely brown this side. A green place, and a brown place, The same TM9 in the same yard seem to show …
It’s going to be almost sunny for three days from tomorrow. The highest temperature on Saturday is 18 degrees Celsius. Can I burn the lawn???
It’s March 1st, 2016. The lawn is completely under the snow again, because of the continuous snow for these 2 days. Conifers and ash in the entrance are also under the snow.
The photo is the Lawn on February 18th, 2016. The snow, which accumulated this week again, is disappearing. This is the lawn today, on February 20th, 2016. The snow’s disappeared but it’s raining a little. The weekly weather forecast says …
This is lawn on March 21st. I removed weeds first. Pulling with Nukerunn-desu Mini. I took out wastepaper basket in the living room instead of bucket and took grasses for two baskets. There still remain some, but it’s OK because …
It rained yesterday and the snow fell last week has almost gone. This is last week, on January 24th. This is today, on January 30th. It’s a big difference. These are conifers and ash in the entrance. The above is …
Lawn on March 26th, 2016, at 6 o’clock in the early morning before staring the work. Vertical cutting, at first. Attache a root cutting blade on Ryobi LM-2800, and set the cutting height in the lowest of 5 mm. In …
